Stability criterion for aluminium alloy milling expressed by recurrence plot measures
Artykuł w czasopiśmie
| Status: | |
| Autorzy: | Rusinek Rafał |
| Rok wydania: | 2012 |
| Wersja dokumentu: | Drukowana | Elektroniczna |
| Język: | angielski |
| Numer czasopisma: | 12 |
| Wolumen/Tom: | 226 |
| Strony: | 1976 - 1985 |
| Impact Factor: | 0,77 |
| Web of Science® Times Cited: | 13 |
| Scopus® Cytowania: | 14 |
| Bazy: | Web of Science | Scopus |
| Efekt badań statutowych | NIE |
| Materiał konferencyjny: | NIE |
| Publikacja OA: | NIE |
| Abstrakty: | angielski |
| This article presents a stability problem of milling process of the Al7075 aluminium alloy. The problem of cutting process stability was often considered in the past but mainly as theoretical research. Here, the stability limit of real cutting process is shown. First, stability lobes diagram was created on the basis of parameters obtained during impact test of end mill cutter. Next, the cutting forces were measured during the test at increasing axial cutting depth. Finally, a methodology of stability analysis based on recurrence plot and recurrence quantification analysis was applied to experimental data. Additionally, new stability indexes were proposed. |
