Influence of Centrifugal Shot Peening Parameters on the Impact Force and Surface Roughness of EN-AW 2024 Aluminum Alloy Elements
Artykuł w czasopiśmie
MNiSW
100
Lista 2021
| Status: | |
| Autorzy: | Skoczylas Agnieszka |
| Dyscypliny: | |
| Aby zobaczyć szczegóły należy się zalogować. | |
| Rok wydania: | 2021 |
| Wersja dokumentu: | Drukowana | Elektroniczna |
| Język: | angielski |
| Numer czasopisma: | 1 |
| Wolumen/Tom: | 15 |
| Strony: | 71 - 78 |
| Web of Science® Times Cited: | 4 |
| Scopus® Cytowania: | 4 |
| Bazy: | Web of Science | Scopus | BazTech |
| Efekt badań statutowych | NIE |
| Materiał konferencyjny: | NIE |
| Publikacja OA: | TAK |
| Licencja: | |
| Sposób udostępnienia: | Otwarte czasopismo |
| Wersja tekstu: | Ostateczna wersja opublikowana |
| Czas opublikowania: | W momencie opublikowania |
| Data opublikowania w OA: | 1 marca 2021 |
| Abstrakty: | angielski |
| This article presents the results of experimental studies of the influence of centrifugal shot peening parameters on the impact force Fu occurring during the machining of the aluminum alloy EN – AW 2024. The surface roughness parameters Ra, Rt, Rpk, RVk and surface topography were also analyzed. Centrifugal shot peening was carried out on the FV-580a vertical machining center using a centrifugal shot peening head. Variable parameters of the centrifugal shot peening were: tangential speed vg and infeed g. Based on the results obtained, it was found that the increase the tangential speed vg and the infeed g causes an increase of the impact force. On the surface of the samples aluminum alloy EN – AW 2024 after centrifugal shot peening numerous micro-cavities were formed, which may can accumulate lubricants in their space. During centrifugal shot peening low values impact force Fu were obtained, which confirms the legitimacy of using this method as a finishing maching of elements with low stiffness. |
