Theoretical and Experimental Identification of Frequency Characteristics and Control Signals of a Dynamic System in the Process of Turning
Artykuł w czasopiśmie
MNiSW
140
Lista 2021
| Status: | |
| Autorzy: | Świć Antoni, Gola Arkadiusz |
| Dyscypliny: | |
| Aby zobaczyć szczegóły należy się zalogować. | |
| Rok wydania: | 2021 |
| Wersja dokumentu: | Drukowana | Elektroniczna |
| Język: | angielski |
| Numer czasopisma: | 9 |
| Wolumen/Tom: | 14 |
| Numer artykułu: | 2260 |
| Strony: | 1 - 16 |
| Impact Factor: | 3,748 |
| Web of Science® Times Cited: | 3 |
| Scopus® Cytowania: | 4 |
| Bazy: | Web of Science | Scopus |
| Efekt badań statutowych | NIE |
| Materiał konferencyjny: | NIE |
| Publikacja OA: | TAK |
| Licencja: | |
| Sposób udostępnienia: | Witryna wydawcy |
| Wersja tekstu: | Ostateczna wersja opublikowana |
| Czas opublikowania: | W momencie opublikowania |
| Data opublikowania w OA: | 27 kwietnia 2021 |
| Abstrakty: | angielski |
| The articlepresents the results of the experimental validation of the developed static, time and frequency characteristics under interference and longitudinal feed control of a dynamic system in the process of turning axisymmetric parts. The experiments were conducted on a test bench,consisting of a 16B16P center lathe, a measuring system and a PC with a measurement card. The experiments were carried out to verify the assumptions of the baseline model of the turning process.As part of the study, we determined the static characteristics of the machining process, the time characteristics of the object under interference and under longitudinal feed rate control, and the frequencycharacteristics of the machine tool system under longitudinal feed rate control. During the experiments, we recorded the observed input and output signal curves and the observed characteristics of the interferences acting on the object, as well as the numerical values of the parameters of the equations describing the model,andin particular the gain of the elastic system,which is difficult to determine by analytical methods.The positive results of the experiments confirm the effectiveness of the proposed models and their usefulness forautomation of machiningprocesses. |
