Effect of Surface Tilt on Nanoindentation Measurement on Copper and Glass
Artykuł w czasopiśmie
MNiSW
100
Lista 2021
| Status: | |
| Autorzy: | Borc Jarosław |
| Dyscypliny: | |
| Aby zobaczyć szczegóły należy się zalogować. | |
| Rok wydania: | 2022 |
| Wersja dokumentu: | Drukowana | Elektroniczna |
| Język: | angielski |
| Numer czasopisma: | 3 |
| Wolumen/Tom: | 16 |
| Strony: | 78 - 88 |
| Impact Factor: | 1,1 |
| Web of Science® Times Cited: | 1 |
| Scopus® Cytowania: | 1 |
| Bazy: | Web of Science | Scopus | BazTech |
| Efekt badań statutowych | NIE |
| Materiał konferencyjny: | NIE |
| Publikacja OA: | TAK |
| Licencja: | |
| Sposób udostępnienia: | Otwarte czasopismo |
| Wersja tekstu: | Ostateczna wersja opublikowana |
| Czas opublikowania: | W momencie opublikowania |
| Data opublikowania w OA: | 15 maja 2022 |
| Abstrakty: | angielski |
| Results of an investigation of the effect of surface tilt in range of 0ο–6ο on nanoindentation measurements under Berkovich indenter at different loads made on copper and glass surfaces are presented and discussed. It was found that: (1) measured hardness increases for tilt angle θ > 3° and this increase is about 12% at θ = 6° for both samples at all applied loads, (2) the overestimation in hardness is due to the increase of projected contact area A with the tilt angle θ, but the theoretical contact area A described by the traditional analytical area function leads to lower change in the hardness than the experimental one up to about 5% may be attributed to the horizontal deflection of the stem holding the indenter, and (3) indentation modulus E is more sensitive to the tilt for glass than copper and the sensitivity in the values of E at a given tilt angle θ increases with decreasing indention load |
