Time Distribution Analysis of 3D Prints with the Use of a Filament and Masked Stereolithography Resin 3D Printer
Artykuł w czasopiśmie
MNiSW
100
Lista 2021
| Status: | |
| Autorzy: | Paśnikowska-Łukaszuk Magdalena, Korulczyk Katarzyna, Kapłon Kamil, Urzędowski Arkadiusz, Wlazło-Ćwiklińska Magda |
| Dyscypliny: | |
| Aby zobaczyć szczegóły należy się zalogować. | |
| Rok wydania: | 2022 |
| Wersja dokumentu: | Drukowana | Elektroniczna |
| Język: | angielski |
| Numer czasopisma: | 5 |
| Wolumen/Tom: | 16 |
| Strony: | 242 - 249 |
| Impact Factor: | 1,1 |
| Web of Science® Times Cited: | 1 |
| Scopus® Cytowania: | 3 |
| Bazy: | Web of Science | Scopus | BazTech |
| Efekt badań statutowych | NIE |
| Materiał konferencyjny: | NIE |
| Publikacja OA: | TAK |
| Licencja: | |
| Sposób udostępnienia: | Otwarte czasopismo |
| Wersja tekstu: | Ostateczna wersja opublikowana |
| Czas opublikowania: | W momencie opublikowania |
| Data opublikowania w OA: | 1 listopada 2022 |
| Abstrakty: | angielski |
| The article focuses on the subject of 3D printing. 3D printing technology and currently used solutions are described. The materials used in printing with the use of a filament printer and a resin printer are discussed. The fused deposiotion modeling technique and the LCD-based stereolithography. Printing technology were presented. Samples were prepared using 3D modeling software. The software used to make the models is discussed. The designed models were printed on two types of printers, using different model orientations. Printouts were measured several times. The obtained data was analyzed and the conclusions, proposed solutions and possible improvements to 3D printing were presented at the end. The article deals with the subject of the possibility of accelerating 3D prints due to their location, but also the influence of warming up the printer during subsequent prints was checked. |
