Research on the Influence of Moisture Exchange between Oil and Cellulose on the Electrical Parameters of the Insulating Oil in Power Transformers
Artykuł w czasopiśmie
MNiSW
140
Lista 2021
| Status: | |
| Autorzy: | Kierczyński Konrad, Rogalski Przemysław, Bondariev Vitalii, Okal Paweł, Korenčiak Daniel |
| Dyscypliny: | |
| Aby zobaczyć szczegóły należy się zalogować. | |
| Rok wydania: | 2022 |
| Wersja dokumentu: | Drukowana | Elektroniczna |
| Język: | angielski |
| Numer czasopisma: | 20 |
| Wolumen/Tom: | 15 |
| Numer artykułu: | 7681 |
| Strony: | 1 - 15 |
| Impact Factor: | 3,2 |
| Web of Science® Times Cited: | 2 |
| Scopus® Cytowania: | 4 |
| Bazy: | Web of Science | Scopus |
| Efekt badań statutowych | NIE |
| Finansowanie: | The research was supported by the subsidy of the Ministry of Education and Science (Poland) for the Lublin University of Technology as funds allocated for scientific activities in the scientific discipline of Automation, Electronics and Electrical Engineering—grants: FD-20/EE-2/701, FD-20/EE-2/702, FD-20/EE-2/705 and FD-20/EE-2/707. |
| Materiał konferencyjny: | NIE |
| Publikacja OA: | TAK |
| Licencja: | |
| Sposób udostępnienia: | Witryna wydawcy |
| Wersja tekstu: | Ostateczna wersja opublikowana |
| Czas opublikowania: | W momencie opublikowania |
| Data opublikowania w OA: | 18 października 2022 |
| Abstrakty: | angielski |
| The article presents an oil moistening method, identical to the oil moistening in power transformers. Moistening took place through the migration of moisture from the moistened pressboard to the brand new oil. The AC electrical parameters (admittance, phase shift angle, permittivity, loss tangent and conductivity) of the brand new and moistened insulating oil were tested. All measured parameters were found to be affected by the oil moistening. The greatest changes were observed in the loss tangent and conductivity. Moisturization increases the value of tanδ at a frequency of 10−4 Hz from about 20 to about 70. With an increase in frequency to about 400–1000 Hz, a minimum is observed, the position of which depends on the temperature. Its value for moistened oil is about six times lower than for brand new oil. This moisturizing increased the activation energy of the conductivity from 0.466 ± 0.0265 eV to 0.890 ± 0.0115 eV. This is likely due to the acceleration of water molecules diffusion from the pressboard into the oil with increasing temperatures. The observed changes in the oil parameters caused by moistening should be taken into account while analyzing the power transformers insulation condition using the FDS method. |
