Effect of Milling Parameters on the Formation of Surface Defects in Polymer Composites
Artykuł w czasopiśmie
MNiSW
40
Lista 2021
| Status: | |
| Autorzy: | Ciecieląg Krzysztof, Zaleski Kazimierz, Kęcik Krzysztof |
| Dyscypliny: | |
| Aby zobaczyć szczegóły należy się zalogować. | |
| Rok wydania: | 2022 |
| Wersja dokumentu: | Drukowana | Elektroniczna |
| Język: | angielski |
| Numer czasopisma: | 6 |
| Wolumen/Tom: | 57 |
| Strony: | 882 - 893 |
| Impact Factor: | 0,9 |
| Web of Science® Times Cited: | 6 |
| Scopus® Cytowania: | 8 |
| Bazy: | Web of Science | Scopus |
| Efekt badań statutowych | NIE |
| Finansowanie: | The project/research was financed within the framework of the Project "Lublin University of Technology—Regional Excellence Initiative" funded by the Polish Ministry of Science and Higher Education (Contract No. 030/RID/2018/19). |
| Materiał konferencyjny: | NIE |
| Publikacja OA: | NIE |
| Abstrakty: | angielski |
| Numerous surface defects in the form of pulled and torn fibers, as well as matrix chipping and ma- trix/fibers interface chipping are determined. The influence of milling parameters on the number of torn fibers and the fraction of defects in the material structure are analyzed. In this study, we use carbon fi- ber-reinforced plastics. The obtained results reveal a significant relationship between the milling pa- rameters and produced defects. It is found that the number of defects strongly depends on the feed speed. The increase in the cutting speed leads to a decrease in the number of defects. |
