Recurrence Quantification Analysis (RQA) of Toroidal End Tool Milling Process
Artykuł w czasopiśmie
MNiSW
100
Lista 2024
| Status: | |
| Autorzy: | Żyłka Łukasz, Płodzień Marcin, Latalski Jarosław, Lajmert Paweł, Rusinek Rafał |
| Dyscypliny: | |
| Aby zobaczyć szczegóły należy się zalogować. | |
| Rok wydania: | 2025 |
| Wersja dokumentu: | Drukowana | Elektroniczna |
| Język: | angielski |
| Numer czasopisma: | 3 |
| Wolumen/Tom: | 15 |
| Numer artykułu: | 1347 |
| Strony: | 1 - 24 |
| Impact Factor: | 2,5 |
| Web of Science® Times Cited: | 4 |
| Scopus® Cytowania: | 4 |
| Bazy: | Web of Science | Scopus |
| Efekt badań statutowych | NIE |
| Materiał konferencyjny: | NIE |
| Publikacja OA: | TAK |
| Licencja: | |
| Sposób udostępnienia: | Witryna wydawcy |
| Wersja tekstu: | Ostateczna wersja opublikowana |
| Czas opublikowania: | W momencie opublikowania |
| Data opublikowania w OA: | 28 stycznia 2025 |
| Abstrakty: | angielski |
| One type of milling process is the face milling of flat surfaces using a toroidal face cutter. A key feature of this process is that changes in the depth of the cut alter the entering angle, impacting milling dynamics by shifting cutting force proportions. To investigate this phenomenon, an experimental study was conducted on the face milling process using different sets of cutting parameters. Cutting force components were recorded, as these signals provide essential information about the milling process. Statistical indicators were then calculated and analyzed based on the recorded data. Following this, a recursive force analysis was performed, and Recurrence Quantification Analysis (RQA) indicators were computed. Relationships between the RQA indicators and the cutting parameters, specifically the feed per tooth (fz) and axial depth of the cut (ap), were established using response surface methodology. Empirical relationships between these parameters were derived. The results indicate that the RQA indicators like the determinism DET, the entropy ENT, and the length of longest vertical line VMAX are correlated with the cutting parameters for both the feed force (Ff) and the component normal to the feed (FfN). In the axial direction, the RQA indicators DET, ENT, and VMAX and also the percentage of recurrence points in a recurrence plot RR and the longest diagonal line length LMAX are shown to be relevant for analyzing the dynamics of the face milling process. |
