Effect of polymer microspheres on selected properties of injection-molded shapes based on thermoplastic starch
Artykuł w czasopiśmie
MNiSW
70
Lista 2024
| Status: | |
| Autorzy: | Jeziórska Regina, Tor-Świątek Aneta, Szadkowska Agnieszka, Klepka Tomasz, Borkowski Mateusz, Skrzypczyńska Katarzyna |
| Dyscypliny: | |
| Aby zobaczyć szczegóły należy się zalogować. | |
| Rok wydania: | 2025 |
| Wersja dokumentu: | Drukowana | Elektroniczna |
| Język: | angielski |
| Numer czasopisma: | 11-12 |
| Wolumen/Tom: | 70 |
| Strony: | 783 - 792 |
| Impact Factor: | 0,8 |
| Scopus® Cytowania: | 0 |
| Bazy: | Scopus |
| Efekt badań statutowych | NIE |
| Materiał konferencyjny: | NIE |
| Publikacja OA: | TAK |
| Licencja: | |
| Sposób udostępnienia: | Witryna wydawcy |
| Wersja tekstu: | Ostateczna wersja opublikowana |
| Czas opublikowania: | W momencie opublikowania |
| Data opublikowania w OA: | 9 grudnia 2025 |
| Abstrakty: | angielski |
| Microporous products were obtained by injection molding. The effect of adding 1-5 wt% of afoaming agent (Expancel® FG92 MB 120) on selected properties of TPS/PBAT blend compatibilized with maleic anhydride-grafted PLA (MPLA) was investigated. The addition of afoaming agent did not significantly affect the wetting properties or the energetic character of the surface. SEM analysis showed that, unlike blow molding, injection molding, due to the high flow rate, high pressure, and rapid cool-ing, leads to the formation of closed but deformed pores. Significant structural variability and increased surface roughness occur along the flow direction, which is not fully correlated with internal porosity. This structure results in only minor changes in mechanical properties compared to the solid material. Density, hardness, tensile strength and elongation at break gradually decrease and moisture absorption increases with increasing foaming agent content. |
