Capabilities of incremental forming of thin-walled products using a universal numerically controlled machine based on numerical simulations
Artykuł w czasopiśmie
MNiSW
100
Lista 2024
| Status: | |
| Autorzy: | Wójcik Jarosław, Tomczak Janusz, Kusiak Tomasz |
| Dyscypliny: | |
| Aby zobaczyć szczegóły należy się zalogować. | |
| Rok wydania: | 2026 |
| Wersja dokumentu: | Drukowana | Elektroniczna |
| Język: | angielski |
| Numer czasopisma: | 7 |
| Wolumen/Tom: | 20 |
| Strony: | 494 - 504 |
| Impact Factor: | 1,5 |
| Web of Science® Times Cited: | 0 |
| Bazy: | Web of Science | BazTech |
| Efekt badań statutowych | NIE |
| Materiał konferencyjny: | NIE |
| Publikacja OA: | TAK |
| Licencja: | |
| Sposób udostępnienia: | Otwarte czasopismo |
| Wersja tekstu: | Ostateczna wersja opublikowana |
| Czas opublikowania: | W momencie opublikowania |
| Data opublikowania w OA: | 1 czerwca 2026 |
| Abstrakty: | angielski |
| Due to the lack of universal machines on the market, this paper presents a new technology and a dedicated machine for manufacturing sheet metal products with various geometries using a single set of tools. The study reports the results of numerical simulations of incremental forming of thin-walled products. The numerical analysis was per- formed on S355 steel sheets with thicknesses ranging from 1 to 5 mm. The bending line followed an arc-shaped trajectory. In the analyzed process, the sheet was deformed using two rollers: a shaping roller and a support roller. Simulations were carried out using Simufact Forming software. Process force parameters, as well as strain and stress distributions, were determined. The maximum forming forces obtained from the numerical simulations ranged from 2 kN for a sheet thickness of 1 mm to 24.5 kN for the maximum analyzed thickness of 5 mm. Pre- liminary numerical simulations indicate that wrinkling may occur in sheets with thicknesses of 1 mm and 2 mm, whereas for thicker sheets this instability was not observed in the simulations. The maximum effective plastic strain recorded for the 5 mm sheet was 1.15, while the maximum von Mises stress reached 724 MPa. Based on the simulation results, it can be stated that the proposed technology shows potential for industrial applications, particularly for single-unit production and prototyping. However, experimental validation is required. |
