Friction Stir Welding of Rapidly Solidified 6082 Alloy: Microstructure and Mechanical Properties
Artykuł w czasopiśmie
MNiSW
40
Lista 2024
| Status: | |
| Autorzy: | Noga Piotr, Kuczek Łukasz, Skrzekut Tomasz, Zwoliński Adam, Szawica Kacper, Kula Anna |
| Dyscypliny: | |
| Aby zobaczyć szczegóły należy się zalogować. | |
| Rok wydania: | 2026 |
| Wersja dokumentu: | Drukowana | Elektroniczna |
| Język: | angielski |
| Numer czasopisma: | 3 |
| Wolumen/Tom: | 71 |
| Strony: | 777 - 786 |
| Impact Factor: | 0,8 |
| Web of Science® Times Cited: | 0 |
| Bazy: | Web of Science |
| Efekt badań statutowych | NIE |
| Finansowanie: | Financial support under contract 501.00 180 000 10000 B02 |
| Materiał konferencyjny: | NIE |
| Publikacja OA: | TAK |
| Licencja: | |
| Sposób udostępnienia: | Witryna wydawcy |
| Wersja tekstu: | Ostateczna wersja opublikowana |
| Czas opublikowania: | W momencie opublikowania |
| Data opublikowania w OA: | 11 września 2026 |
| Abstrakty: | angielski |
| This study investigates the microstructure and mechanical properties of friction stir welded (FSW ) joints produced from AA6082 alloy fabricated by rapid solidification and hot extrusion. The base material exhibited a homogeneous microstructure with a fine average grain size of ~1.3 μm, significantly lower than the 5.5 μm measured for the conventionally processed reference material. The most favorable joint properties were obtained at a tool rotational speed of 1000 rpm. Under these conditions, the welded joint showed strength comparable to the base material, reaching 206 MP a UTS and 151 MP a YS, although with reduced ductility. EBSD analysis revealed only minor microstructural changes after welding, with the grain size in the stir zone remaining nearly unchanged at approximately 1.5 μm. These results demonstrate that the fine-grained microstructure of the rapidly solidified AA 6082 alloy is largely preserved during FSW and highlight its potential for solid-state joining applications. |
