Impact of depth of cut on chip formation in AZ91HP magnesium alloy milling with tools of varying cutting edge geometry
Artykuł w czasopiśmie
MNiSW
9
Lista B
| Status: | |
| Autorzy: | Gziut Olga, Kuczmaszewski Józef, Zagórski Ireneusz |
| Rok wydania: | 2015 |
| Wersja dokumentu: | Drukowana | Elektroniczna |
| Język: | angielski |
| Numer czasopisma: | 26 |
| Wolumen/Tom: | 9 |
| Strony: | 49 - 56 |
| Web of Science® Times Cited: | 3 |
| Bazy: | Web of Science | BazTech |
| Efekt badań statutowych | NIE |
| Materiał konferencyjny: | NIE |
| Publikacja OA: | TAK |
| Licencja: | |
| Sposób udostępnienia: | Otwarte czasopismo |
| Wersja tekstu: | Ostateczna wersja opublikowana |
| Czas opublikowania: | W momencie opublikowania |
| Data opublikowania w OA: | 14 maja 2015 |
| Abstrakty: | angielski |
| Safety of Mg milling processes can be expressed by means of the form and the number of fractions of chips formed during milling. This paper presents the state of the art of magnesium alloys milling technology in the aspect of chip fragmentation. Furthermore, the impact of the depth of cut ap and the rake angle γ on the number of chip fractions was analysed in the study. These were conducted on AZ91HP magnesium cast alloy and milling was performed with carbide tools of varying rake angle values (γ = 5º and γ = 30º). It was observed that less intense chip fragmentation occurs with decreasing depth of cut ap. The number of chip fractions was lower at the tool rake angle of γ = 30º. The test results were formulated as technological recommendations according to the number of generated chip fractions. |
