New forming possibilities in cross wedge rolling processes
Artykuł w czasopiśmie
MNiSW
30
Lista A
| Status: | |
| Autorzy: | Pater Zbigniew, Tomczak Janusz, Bulzak Tomasz |
| Dyscypliny: | |
| Aby zobaczyć szczegóły należy się zalogować. | |
| Rok wydania: | 2018 |
| Wersja dokumentu: | Drukowana | Elektroniczna |
| Język: | angielski |
| Numer czasopisma: | 1 |
| Wolumen/Tom: | 18 |
| Strony: | 149 - 161 |
| Impact Factor: | 2,846 |
| Web of Science® Times Cited: | 29 |
| Scopus® Cytowania: | 32 |
| Bazy: | Web of Science | Scopus | Science Direct |
| Efekt badań statutowych | NIE |
| Materiał konferencyjny: | NIE |
| Publikacja OA: | NIE |
| Abstrakty: | angielski |
| The paper describes limitations in the process of cross wedge rolling (CWR). The problem of necking (rupture) of a shaft step is discussed in detail. In addition, the paper also overviews the state of the art of modelling the cross wedge rolling process by the finite element method-based software, Deform-3D. Next, the paper presents methods for increasing effectiveness in two types of CWR: cross wedge rolling where axial flow of metal is blocked and cross wedge rolling with upsetting. The proposed rolling methods are then verified numerically by Deform-3D. Finally, the presented solutions are verified in experimental tests of a rolling process for producing a lever (with blocked axial flow of metal) and for an upset rolling process for producing a driving shaft. |
