Fly ash-derived MCM-41 as a low-cost silica support for polyethyleneimine in post-combustion CO2 capture
Artykuł w czasopiśmie
MNiSW
40
Lista A
| Status: | |
| Autorzy: | Panek Rafał, Wdowin Magdalena, Franus Wojciech, Czarna Dorota, Stevens Lee A, Deng Hui, Liu Junpeng, Sun Cheng-Gong, Liu Hao, Snape Colin E. |
| Dyscypliny: | |
| Aby zobaczyć szczegóły należy się zalogować. | |
| Rok wydania: | 2017 |
| Wersja dokumentu: | Drukowana | Elektroniczna |
| Język: | angielski |
| Wolumen/Tom: | 22 |
| Strony: | 81 - 90 |
| Impact Factor: | 5,503 |
| Web of Science® Times Cited: | 86 |
| Scopus® Cytowania: | 93 |
| Bazy: | Web of Science | Scopus |
| Efekt badań statutowych | NIE |
| Materiał konferencyjny: | NIE |
| Publikacja OA: | TAK |
| Licencja: | |
| Sposób udostępnienia: | Witryna wydawcy |
| Wersja tekstu: | Ostateczna wersja opublikowana |
| Czas opublikowania: | W momencie opublikowania |
| Data opublikowania w OA: | 6 listopada 2017 |
| Abstrakty: | angielski |
| The mesoporous silicate molecular sieve, MCM-41, has been synthesized from pulverized coal fly ash (PFA), where the silicate filtrate used is a by-product from hydrothermal zeolite production. Rice husk ash was also used for comparison but fusion with sodium hydroxide was used to prepare the silicate filtrate, along similar lines to earlier reports of using PFA as a precursor for MCM-41 synthesis. The MCM-41 samples are chemically and mineralogically similar to a commercially available sample, but with higher pore volumes dominated by mesopores (0.92–1.13 cf. 0.88 cm3 g−1). After polyethyleneimine (PEI) impregnation for CO2 capture, the ash derived MCM-41 samples displayed higher uptakes than the commercial sample with the maximum achievable PEI loading of 60 Wt.% PEI (dry basis) before particle agglomeration occurs, approximately 13 compared to 11 Wt.%, respectively, the latter being comparable to earlier reports in the literature. The PFA sample that displays the fastest kinetics to achieve 90% of the equilibrium uptake had the largest mesopore volume of 1.13 cm3 g−1. Given the PFA-derived MCM-41 uses a waste silicate solution for hydrothermal preparation and no prior preparation is needed, production costs are estimated to be considerable lower where silicate solutions need to be prepared by base treatment, even if ash is used, as for the RHA derived MCM-41 used here. |
