The influence of layer height on the quality of 3D print for selected construction materials
Artykuł w czasopiśmie
MNiSW
5
spoza listy
| Status: | |
| Autorzy: | Sarnecki Oskar, Skiba Antoni , Sowa Mikołaj, Prykhodzenko Valerii , Kłonica Mariusz |
| Dyscypliny: | |
| Aby zobaczyć szczegóły należy się zalogować. | |
| Rok wydania: | 2024 |
| Wersja dokumentu: | Elektroniczna |
| Język: | angielski |
| Numer czasopisma: | 1 |
| Wolumen/Tom: | 3 |
| Strony: | 1 - 15 |
| Efekt badań statutowych | NIE |
| Materiał konferencyjny: | NIE |
| Publikacja OA: | TAK |
| Licencja: | |
| Sposób udostępnienia: | Otwarte czasopismo |
| Wersja tekstu: | Ostateczna wersja opublikowana |
| Czas opublikowania: | W momencie opublikowania |
| Data opublikowania w OA: | 8 września 2025 |
| Abstrakty: | angielski |
| Typical rapid prototyping is based on additive manufacturing tech-niques. Prototype design is a particular challenge for technologists. The very essence of the concept of prototype suggests that we are dealing with something new, which means that there is usually no prior knowledge or experience. Documentation must be simplified and often provide alterna-tives. The physical properties of the materials from which a part, device or machine will be manufactured are not always clearly defined. Of course, the costof producing a prototype also plays an important role. However, this is difficult to estimate at the prototype design stage. This manuscript presents the development of 3D additive technologies, machines used in additive manufacturing processes and materials used for printing. The purpose of this study was to investigate the layer thickness of 3D printed specimens for the strength and stereometric properties of the sur-face layer. The tests were carried out on a Zwick/Roell Z150 testing ma-chine. The results of selected surface roughness parameters obtained with the use of the T8000 RC120-400 profilometer from Hommel-Etamic were analyzed. The results of the manuscript will not only allow you to better understand the basics of additive manufacturing, but alsoprovide specific data that can facilitate the selection of appropriate machines, materials and printing parameters in order to obtain an element with the right prop-erties. |
